From d6a3873c7be6d58914ea5584dc7875f2045d6721 Mon Sep 17 00:00:00 2001 From: Martin Blumenstingl Date: Sat, 20 Jun 2020 18:36:54 +0200 Subject: [PATCH] ARM: dts: meson8b: odroidc1: enable the SDHC controller Odroid-C1 has an eMMC connector where users can optionally install an eMMC module. The eMMC modules run off a 1.8V VQMMC supply which means that HS-200 mode can be used (this is the highest mode that the SDHC controller supports). Enable the SDHC controller so eMMC modules can be accessed. Signed-off-by: Martin Blumenstingl Signed-off-by: Kevin Hilman Link: https://lore.kernel.org/r/20200620163654.37207-4-martin.blumenstingl@googlemail.com --- arch/arm/boot/dts/meson8b-odroidc1.dts | 26 ++++++++++++++++++++++++++ 1 file changed, 26 insertions(+) diff --git a/arch/arm/boot/dts/meson8b-odroidc1.dts b/arch/arm/boot/dts/meson8b-odroidc1.dts index cb21ac9f517c..0c26467de4d0 100644 --- a/arch/arm/boot/dts/meson8b-odroidc1.dts +++ b/arch/arm/boot/dts/meson8b-odroidc1.dts @@ -15,6 +15,7 @@ aliases { serial0 = &uart_AO; mmc0 = &sd_card_slot; + mmc1 = &sdhc; }; chosen { @@ -26,6 +27,11 @@ reg = <0x40000000 0x40000000>; }; + emmc_pwrseq: emmc-pwrseq { + compatible = "mmc-pwrseq-emmc"; + reset-gpios = <&gpio BOOT_9 GPIO_ACTIVE_LOW>; + }; + leds { compatible = "gpio-leds"; blue { @@ -310,6 +316,26 @@ vref-supply = <&vcc_1v8>; }; +&sdhc { + status = "okay"; + + pinctrl-0 = <&sdxc_c_pins>; + pinctrl-names = "default"; + + bus-width = <8>; + max-frequency = <100000000>; + + disable-wp; + cap-mmc-highspeed; + mmc-hs200-1_8v; + no-sdio; + + mmc-pwrseq = <&emmc_pwrseq>; + + vmmc-supply = <&vcc_3v3>; + vqmmc-supply = <&vcc_1v8>; +}; + &sdio { status = "okay"; -- 2.17.1