memory: brcmstb_dpfe: add separate entry for compile test

Add separate entry for Broadcom STB DPFE driver, enabled by default on
ARCH_BRCMSTB.  This allows compile testing.

Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
Acked-by: Florian Fainelli <f.fainelli@gmail.com>

diff --git a/drivers/memory/Kconfig b/drivers/memory/Kconfig
index 2c79e95..7443280 100644 (file)
--- a/drivers/memory/Kconfig
+++ b/drivers/memory/Kconfig
@@ -52,6 +52,18 @@ config ATMEL_EBI
          tree is used. This bus supports NANDs, external ethernet controller,
          SRAMs, ATA devices, etc.
 
+config BRCMSTB_DPFE
+       bool "Broadcom STB DPFE driver" if COMPILE_TEST
+       default y if ARCH_BRCMSTB
+       depends on ARCH_BRCMSTB || COMPILE_TEST
+       help
+         This driver provides access to the DPFE interface of Broadcom
+         STB SoCs. The firmware running on the DCPU inside the DDR PHY can
+         provide current information about the system's RAM, for instance
+         the DRAM refresh rate. This can be used as an indirect indicator
+         for the DRAM's temperature. Slower refresh rate means cooler RAM,
+         higher refresh rate means hotter RAM.
+
 config BT1_L2_CTL
        bool "Baikal-T1 CM2 L2-RAM Cache Control Block"
        depends on MIPS_BAIKAL_T1 || COMPILE_TEST

diff --git a/drivers/memory/Makefile b/drivers/memory/Makefile
index b4533ff..e71cf7b 100644 (file)
--- a/drivers/memory/Makefile
+++ b/drivers/memory/Makefile
@@ -10,7 +10,7 @@ endif
 obj-$(CONFIG_ARM_PL172_MPMC)   += pl172.o
 obj-$(CONFIG_ATMEL_SDRAMC)     += atmel-sdramc.o
 obj-$(CONFIG_ATMEL_EBI)                += atmel-ebi.o
-obj-$(CONFIG_ARCH_BRCMSTB)     += brcmstb_dpfe.o
+obj-$(CONFIG_BRCMSTB_DPFE)     += brcmstb_dpfe.o
 obj-$(CONFIG_BT1_L2_CTL)       += bt1-l2-ctl.o
 obj-$(CONFIG_TI_AEMIF)         += ti-aemif.o
 obj-$(CONFIG_TI_EMIF)          += emif.o