--- /dev/null
+/* SPDX-License-Identifier: GPL-2.0+ */
+/*
+ * Copyright 2018 NXP
+ */
+
+#ifndef __IMX8MN_EVK_H
+#define __IMX8MN_EVK_H
+
+#include <linux/sizes.h>
+#include <linux/stringify.h>
+#include <asm/arch/imx-regs.h>
+#include "imx_env.h"
+
+#define CONFIG_SYS_BOOTM_LEN (32 * SZ_1M)
+
+#define CONFIG_SPL_MAX_SIZE (208 * 1024)
+#define CONFIG_SYS_MONITOR_LEN (512 * 1024)
+#define CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR
+#define CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR 0x300
+#define CONFIG_SYS_UBOOT_BASE \
+ (QSPI0_AMBA_BASE + CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR * 512)
+
+#ifdef CONFIG_SPL_BUILD
+#define CONFIG_SPL_STACK 0x95dff0
+#define CONFIG_SPL_BSS_START_ADDR 0x95e000
+#define CONFIG_SPL_BSS_MAX_SIZE SZ_8K /* 8 KB */
+#define CONFIG_SYS_SPL_MALLOC_START 0x42200000
+#define CONFIG_SYS_SPL_MALLOC_SIZE SZ_512K /* 512 KB */
+
+/* For RAW image gives a error info not panic */
+#define CONFIG_SPL_ABORT_ON_RAW_IMAGE
+
+#if defined(CONFIG_NAND_BOOT)
+#define CONFIG_SPL_NAND_SUPPORT
+#define CONFIG_SPL_DMA
+#define CONFIG_SPL_NAND_MXS
+#define CONFIG_SPL_NAND_BASE
+#define CONFIG_SPL_NAND_IDENT
+#define CONFIG_SYS_NAND_U_BOOT_OFFS 0x4000000 /* Put the FIT out of first 64MB boot area */
+
+/* Set a redundant offset in nand FIT mtdpart. The new uuu will burn full boot image (not only FIT part) to the mtdpart, so we check both two offsets */
+#define CONFIG_SYS_NAND_U_BOOT_OFFS_REDUND \
+ (CONFIG_SYS_NAND_U_BOOT_OFFS + CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR * 512 - 0x8400)
+#endif
+
+#endif
+
+#define CONFIG_CMD_READ
+#define CONFIG_SERIAL_TAG
+#define CONFIG_FASTBOOT_USB_DEV 0
+
+#define CONFIG_REMAKE_ELF
+/* ENET Config */
+/* ENET1 */
+#if defined(CONFIG_FEC_MXC)
+#define CONFIG_ETHPRIME "FEC"
+#define PHY_ANEG_TIMEOUT 20000
+
+#define CONFIG_FEC_XCV_TYPE RGMII
+#define CONFIG_FEC_MXC_PHYADDR 0
+
+#define IMX_FEC_BASE 0x30BE0000
+#endif
+
+#ifdef CONFIG_DISTRO_DEFAULTS
+#define BOOT_TARGET_DEVICES(func) \
+ func(USB, usb, 0) \
+ func(MMC, mmc, 1) \
+ func(MMC, mmc, 2)
+
+#include <config_distro_bootcmd.h>
+#else
+#define BOOTENV
+#endif
+
+/*
+ * Another approach is add the clocks for inmates into clks_init_on
+ * in clk-imx8mm.c, then clk_ingore_unused could be removed.
+ */
+#ifdef CONFIG_TARGET_IMX8MN_DDR4_EVK
+#define JH_ROOT_DTB "imx8mn-ddr4-evk-root.dtb"
+#else
+#define JH_ROOT_DTB "imx8mn-evk-root.dtb"
+#endif
+
+#define JAILHOUSE_ENV \
+ "jh_clk= \0 " \
+ "jh_root_dtb=" JH_ROOT_DTB "\0" \
+ "jh_mmcboot=mw 0x303d0518 0xff; setenv fdtfile ${jh_root_dtb};" \
+ "setenv jh_clk clk_ignore_unused mem=1340MB; " \
+ "if run loadimage; then " \
+ "run mmcboot; " \
+ "else run jh_netboot; fi; \0" \
+ "jh_netboot=mw 0x303d0518 0xff; setenv fdtfile ${jh_root_dtb}; setenv jh_clk clk_ignore_unused mem=1340MB; run netboot; \0 "
+
+#define CONFIG_MFG_ENV_SETTINGS \
+ CONFIG_MFG_ENV_SETTINGS_DEFAULT \
+ "initrd_addr=0x43800000\0" \
+ "initrd_high=0xffffffffffffffff\0" \
+ "emmc_dev=2\0"\
+ "sd_dev=1\0" \
+
+/* Initial environment variables */
+#define CONFIG_EXTRA_ENV_SETTINGS \
+ CONFIG_MFG_ENV_SETTINGS \
+ JAILHOUSE_ENV \
+ BOOTENV \
+ "scriptaddr=0x43500000\0" \
+ "kernel_addr_r=" __stringify(CONFIG_LOADADDR) "\0" \
+ "bsp_script=boot.scr\0" \
+ "image=Image\0" \
+ "splashimage=0x50000000\0" \
+ "console=ttymxc1,115200\0" \
+ "fdt_addr_r=0x43000000\0" \
+ "fdt_addr=0x43000000\0" \
+ "fdt_high=0xffffffffffffffff\0" \
+ "boot_fit=no\0" \
+ "fdtfile=" CONFIG_DEFAULT_FDT_FILE "\0" \
+ "bootm_size=0x10000000\0" \
+ "mmcdev="__stringify(CONFIG_SYS_MMC_ENV_DEV)"\0" \
+ "mmcpart=" __stringify(CONFIG_SYS_MMC_IMG_LOAD_PART) "\0" \
+ "mmcroot=" CONFIG_MMCROOT " rootwait rw\0" \
+ "mmcautodetect=yes\0" \
+ "mmcargs=setenv bootargs ${jh_clk} console=${console} root=${mmcroot}\0 " \
+ "loadbootscript=fatload mmc ${mmcdev}:${mmcpart} ${loadaddr} ${bsp_script};\0" \
+ "bootscript=echo Running bootscript from mmc ...; " \
+ "source\0" \
+ "loadimage=fatload mmc ${mmcdev}:${mmcpart} ${loadaddr} ${image}\0" \
+ "loadfdt=fatload mmc ${mmcdev}:${mmcpart} ${fdt_addr_r} ${fdtfile}\0" \
+ "mmcboot=echo Booting from mmc ...; " \
+ "run mmcargs; " \
+ "if test ${boot_fit} = yes || test ${boot_fit} = try; then " \
+ "bootm ${loadaddr}; " \
+ "else " \
+ "if run loadfdt; then " \
+ "booti ${loadaddr} - ${fdt_addr_r}; " \
+ "else " \
+ "echo WARN: Cannot load the DT; " \
+ "fi; " \
+ "fi;\0" \
+ "netargs=setenv bootargs ${jh_clk} console=${console} " \
+ "root=/dev/nfs " \
+ "ip=dhcp nfsroot=${serverip}:${nfsroot},v3,tcp\0" \
+ "netboot=echo Booting from net ...; " \
+ "run netargs; " \
+ "if test ${ip_dyn} = yes; then " \
+ "setenv get_cmd dhcp; " \
+ "else " \
+ "setenv get_cmd tftp; " \
+ "fi; " \
+ "${get_cmd} ${loadaddr} ${image}; " \
+ "if test ${boot_fit} = yes || test ${boot_fit} = try; then " \
+ "bootm ${loadaddr}; " \
+ "else " \
+ "if ${get_cmd} ${fdt_addr_r} ${fdtfile}; then " \
+ "booti ${loadaddr} - ${fdt_addr_r}; " \
+ "else " \
+ "echo WARN: Cannot load the DT; " \
+ "fi; " \
+ "fi;\0" \
+ "bsp_bootcmd=echo Running BSP bootcmd ...; " \
+ "mmc dev ${mmcdev}; if mmc rescan; then " \
+ "if run loadbootscript; then " \
+ "run bootscript; " \
+ "else " \
+ "if run loadimage; then " \
+ "run mmcboot; " \
+ "else run netboot; " \
+ "fi; " \
+ "fi; " \
+ "fi;"
+
+
+/* Link Definitions */
+#define CONFIG_LOADADDR 0x40480000
+
+#define CONFIG_SYS_LOAD_ADDR CONFIG_LOADADDR
+
+#define CONFIG_SYS_INIT_RAM_ADDR 0x40000000
+#define CONFIG_SYS_INIT_RAM_SIZE 0x80000
+#define CONFIG_SYS_INIT_SP_OFFSET \
+ (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
+#define CONFIG_SYS_INIT_SP_ADDR \
+ (CONFIG_SYS_INIT_RAM_ADDR + CONFIG_SYS_INIT_SP_OFFSET)
+
+#if defined(CONFIG_ENV_IS_IN_SPI_FLASH)
+#define CONFIG_ENV_SPI_BUS CONFIG_SF_DEFAULT_BUS
+#define CONFIG_ENV_SPI_CS CONFIG_SF_DEFAULT_CS
+#define CONFIG_ENV_SPI_MODE CONFIG_SF_DEFAULT_MODE
+#define CONFIG_ENV_SPI_MAX_HZ CONFIG_SF_DEFAULT_SPEED
+#endif
+#define CONFIG_MMCROOT "/dev/mmcblk1p2" /* USDHC2 */
+
+/* Size of malloc() pool */
+#define CONFIG_SYS_MALLOC_LEN SZ_32M
+
+#define CONFIG_SYS_SDRAM_BASE 0x40000000
+#define PHYS_SDRAM 0x40000000
+
+#ifdef CONFIG_TARGET_IMX8MN_DDR3_EVK
+#define PHYS_SDRAM_SIZE 0x40000000 /* 1GB DDR */
+#else
+#define PHYS_SDRAM_SIZE 0x80000000 /* 2GB DDR */
+#endif
+
+#define CONFIG_MXC_UART_BASE UART2_BASE_ADDR
+
+/* Monitor Command Prompt */
+#define CONFIG_SYS_CBSIZE 2048
+#define CONFIG_SYS_MAXARGS 64
+#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE
+#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE + \
+ sizeof(CONFIG_SYS_PROMPT) + 16)
+
+#define CONFIG_IMX_BOOTAUX
+
+/* USDHC */
+#define CONFIG_FSL_USDHC
+
+#define CONFIG_SYS_FSL_USDHC_NUM 2
+#define CONFIG_SYS_FSL_ESDHC_ADDR 0
+
+#define CONFIG_SYS_MMC_IMG_LOAD_PART 1
+
+#ifdef CONFIG_NAND_MXS
+#define CONFIG_CMD_NAND_TRIMFFS
+
+/* NAND stuff */
+#define CONFIG_SYS_MAX_NAND_DEVICE 1
+#define CONFIG_SYS_NAND_BASE 0x20000000
+#define CONFIG_SYS_NAND_5_ADDR_CYCLE
+#define CONFIG_SYS_NAND_ONFI_DETECTION
+#define CONFIG_SYS_NAND_USE_FLASH_BBT
+#endif /* CONFIG_NAND_MXS */
+
+#define CONFIG_SYS_I2C_SPEED 100000
+
+/* USB configs */
+#ifndef CONFIG_SPL_BUILD
+#define CONFIG_USBD_HS
+
+#define CONFIG_CMD_USB_MASS_STORAGE
+#define CONFIG_USB_GADGET_MASS_STORAGE
+#define CONFIG_USB_FUNCTION_MASS_STORAGE
+
+#endif
+
+#define CONFIG_USB_GADGET_VBUS_DRAW 2
+
+#define CONFIG_MXC_USB_PORTSC (PORT_PTS_UTMI | PORT_PTS_PTW)
+#define CONFIG_USB_MAX_CONTROLLER_COUNT 2
+
+#ifdef CONFIG_DM_VIDEO
+#define CONFIG_VIDEO_MXS
+#define CONFIG_VIDEO_LOGO
+#define CONFIG_BMP_16BPP
+#define CONFIG_BMP_24BPP
+#define CONFIG_BMP_32BPP
+#define CONFIG_VIDEO_BMP_RLE8
+#define CONFIG_VIDEO_BMP_LOGO
+#endif
+
+#ifdef CONFIG_ANDROID_SUPPORT
+#include "imx8mn_evk_android.h"
+#endif
+
+#endif
projects / u-boot.git / commitdiff