MLK-21848-7 serial_lpuart: Check CONFIG_SPL_CLK when using clk driver in SPL

Should use CONFIG_IS_ENABLED not IS_ENABLED for CLK driver, so it will
check the CONFIG_SPL_CLK when building SPL

Signed-off-by: Ye Li <ye.li@nxp.com>

diff --git a/drivers/serial/serial_lpuart.c b/drivers/serial/serial_lpuart.c
index a357b00..5f6329f 100644 (file)
--- a/drivers/serial/serial_lpuart.c
+++ b/drivers/serial/serial_lpuart.c
@@ -105,7 +105,7 @@ u32 __weak get_lpuart_clk(void)
        return CONFIG_SYS_CLK_FREQ;
 }
 
-#if IS_ENABLED(CONFIG_CLK)
+#if CONFIG_IS_ENABLED(CLK)
 static int get_lpuart_clk_rate(struct udevice *dev, u32 *clk)
 {
        struct clk per_clk;
@@ -147,7 +147,7 @@ static void _lpuart_serial_setbrg(struct udevice *dev,
        u16 sbr;
        int ret;
 
-       if (IS_ENABLED(CONFIG_CLK)) {
+       if (CONFIG_IS_ENABLED(CLK)) {
                ret = get_lpuart_clk_rate(dev, &clk);
                if (ret)
                        return;
@@ -236,7 +236,7 @@ static void _lpuart32_serial_setbrg_7ulp(struct udevice *dev,
        u32 clk;
        int ret;
 
-       if (IS_ENABLED(CONFIG_CLK)) {
+       if (CONFIG_IS_ENABLED(CLK)) {
                ret = get_lpuart_clk_rate(dev, &clk);
                if (ret)
                        return;
@@ -305,7 +305,7 @@ static void _lpuart32_serial_setbrg(struct udevice *dev,
        u32 sbr;
        int ret;
 
-       if (IS_ENABLED(CONFIG_CLK)) {
+       if (CONFIG_IS_ENABLED(CLK)) {
                ret = get_lpuart_clk_rate(dev, &clk);
                if (ret)
                        return;